Composites Central

Go Back   Composites Central > General Composites Discussions > Composites Talk

Reply
Old 01-06-2016, 09:21 PM   #1
BSR

Member
 
Join Date: Jan 2008
Location: PA
Posts: 23
Thanks: 3
Thanked 0 Times in 0 Posts



Default Carbon steering wheel will this way of building work

Looking to make a carbon fiber steering wheel upon reading rubber silicone insert would be the best way to go at this. The article I read on this process wad using prepreg and relying on the Silicone insert to expand and put pressure on the die when heated to temp to cure. I do not have an oven and would like to infuse or wet lay and bag the part. If I have both halfs made and made a silicone insert would I be able to wet lay one half and put the silicone inert in and wrap the edge part of the way over for glue surface vacuum bag it?do the same with the other side only wrap opposite side partly over insert for more glue surface when joining. Would this process work out. Thankyou everyone again
BSR is offline   Reply With Quote
Reply

Bookmarks

Tags
building, carbon, steering, wheel, work

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -8. The time now is 05:05 AM.
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2018, vBulletin Solutions, Inc.

Inactive Reminders By Icora Web Design