|08-07-2015, 11:06 AM||#1|
Join Date: Jul 2015
Location: USA, Maryland
Thanked 0 Times in 0 Posts
Infusion issues - Need advice!
So I'm having some infusion issues with a project I'm working on and wanted some advice. I'm having some issues with surface porosity on my part.
I suspect its an issue related to infusion speed, my part is relative small and infuses in like 10 or 15 seconds. Imagine a large bowl shaped part.
I've switched from green to red infusion mesh and I'm considering reducing the infusion spiral and resin inlet diameter.
Any thoughts? Thanks in advance!
|advice, infusion, issues|